How a record plays

How a record plays

Sound is cut into vinyl as the shape of one long spiral groove. The turntable spins it at a steady speed, the tonearm lets a diamond stylus follow the groove, and a tiny generator in the cartridge turns the stylus's wiggles back into an electrical signal.

Cartridge, cantilever and the groove the stylus is reading nowPlatter and 12-inch LP, music from 146 mm in to 60.3 mmTonearm: counterweight, gimbal, tube and offset headshellA 12-inch LP holds one continuous spiral groove, about 732 turns on a 22-minute side, 0.117 mm apart on average. The platter turns it at 33⅓ rpm, so the groove passes the stylus at about 0.51 m/s on the outside and only 0.21 m/s near the label. The tonearm swings on a pivot 215 mm from the spindle; its 230 mm effective length and 15 mm overhang, with the headshell turned 22.7°, keep the cartridge within 1.9° of the groove's direction from lead-in to run-out. The tour plays a side about 80 times faster than life; the readout's time is where that groove really falls on the side.
Groove walls, diamond, cantilever and magnet: everything that movesFour coils on pole pieces: left channel on one diagonal, right on the otherOutput pins: L+ white, L− blue, R+ red, R− greenThe groove is a V with walls at 45°, about 60 µm wide at the top. Each wall carries one channel: left on the inner wall, right on the outer. Sound the same in both and the walls wiggle together, so the stylus swings side to side; sound in one channel only and it moves along that wall's 45° line. The diamond drives a cantilever that rocks in a rubber damper, and the magnet on its far end swings between four pole pieces, inducing a voltage in each pair of coils. At the usual 5 cm/s reference level a typical cartridge gives about 5 mV per channel, and at 1 kHz the tip moves only about 8 µm, so the groove and the motion are drawn tens of times larger than life and in slow motion; the readout gives the real values.